DOUBLE FACED-CARD Vertical Slip-In Badge-ID holder

A simple badge/ id card holder with slip-in design.

NEW VERSION!

Use it while traveling, commuting from home to work, or whenever you need it.

This design allows you to carry up to two card at the same time. For expample, you can put on one side your office badge and on the other side the travel card. One holder for all.

Main Features:

• Vertical Print - Optimized to be printed without supports
• Slip-in design: fast insert and removal of cards
• Double face design
• Up to two cards at the same time with easy access
• VERTICAL and HORIZONTAL, check print profile section

This print profile uses brim to maximize the adhesion on the bed. The settings are set to make it easy removable. After the removal some subtle white lines could remain at the bottom, you can gently clean them with a sharp blade or some fine abrasive paper.

Check also the other versions:

• 1 card slot version - SINGLE SIDE - Vertical print
• 1-2 card slot version - SINGLE SIDE FLAT and FAST PRINT

Since I don't like printing with supports I tried to optimize the design and settings to print it without them. I tried many orientations and versions with supports but I encountered issues with removal or surface quality.

Use the settings provided to ensure the best performances. TESTED ON THE P1S.

Please if you test or optimize this to be printed on the A1 series, please consider sharing the print profile!

Post your print in the comment and show what color have you chose!

Thumbs up if you like the design!

Consider to boost if it deserves :D